From: Siddharth Rath (sirath) <sirath@cisco.com>
To: pgsql-admin@postgresql.org
Subject: URGENT : StreamServerPort: bind() failed: Cannot assign requested address
Date: Thu, 3 Jun 2004 19:22:32 -0700
Message-ID: <09af01c449da$cb2e3dc0$2c6345ab@amer.cisco.com> (raw)
Hi,
I've an application running on RedHat Linux and we are using Postgres as our DB. Initially the DB was running perfectly but due to
some requirement we stopped the DB with " pg_ctl stop -m 'fast' " command. When I tried to restart the DB/Postmaster it says :
StreamServerPort: bind() failed: Cannot assign requested address
Is another postmaster already running on port 5432?
If not, wait a few seconds and retry.
cannot create INET stream port
Since I don't have root access , I took the help of the Sysadmin to reboot the system and the DB server(POSTGRES) started correctly
, but when I stopped the DB server with above mentioned command and started again it throws back the same old error. Is there anyway
to get rid of these.
I found some details in archieves at http://list.linux-vserver.org/archive/vserver/msg04095.html . But I don't understand what to do
next.
The O/P of >netstat -plunt | grep 5432
(Not all processes could be identified, non-owned process info
will not be shown, you would have to be root to see it all.)
tcp 0 0 0.0.0.0:54320 0.0.0.0:* LISTEN -
udp 0 0 0.0.0.0:54321 0.0.0.0:* -
And O/P of netstat -ranv
Kernel IP routing table
Destination Gateway Genmask Flags MSS Window irtt Iface
10.83.103.0 0.0.0.0 255.255.255.192 U 0 0 0 eth2
64.102.29.0 0.0.0.0 255.255.255.0 U 0 0 0 eth0
169.254.0.0 0.0.0.0 255.255.0.0 U 0 0 0 eth2
127.0.0.0 0.0.0.0 255.0.0.0 U 0 0 0 lo
0.0.0.0 64.102.29.1 0.0.0.0 UG 0 0 0 eth0
Any pointers/help in resolving this issue will be highly appreciated.
Thanx and regards
Sidd
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Reply to all the recipients from your mail client; the link fills in
the headers below: reply via email
Some clients, webmail especially, drop In-Reply-To and References from
a link, and the reply then starts a new thread: use the mbox below.
To: pgsql-admin@postgresql.org
Cc: sirath@cisco.com
Subject: Re: URGENT : StreamServerPort: bind() failed: Cannot assign requested address
In-Reply-To: <09af01c449da$cb2e3dc0$2c6345ab@amer.cisco.com>
References: <09af01c449da$cb2e3dc0$2c6345ab@amer.cisco.com>
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
This inbox is served by DDX for PostgreSQL; see mirroring instructions
for how to clone and mirror all data and code used for this inbox