pg.ddx.io  pgsql-admin@postgresql.org mailing list archive  
help / color / mirror / Atom feed
From: Scott Marlowe <smarlowe@g2switchworks.com>
To: KÖPFERL Robert <robert.koepferl@sonorys.at>
Cc: pgsql-admin@postgresql.org
Subject: Re: Stripping raid vs. table spaces
Date: Thu, 09 Jun 2005 09:11:53 -0500
Message-ID: <1118326313.5758.189.camel@state.g2switchworks.com> (raw)
In-Reply-To: <ED4E30DD9C43D5118DFB00508BBBA76EB16753@neptun.sonorys.at>
References: <ED4E30DD9C43D5118DFB00508BBBA76EB16753@neptun.sonorys.at>

On Thu, 2005-06-09 at 02:16, KÖPFERL Robert wrote:
> Short question:
> 
> Is it enugh to have stripping on a disk array?
> Are table spaces then of less use than the actual stripping? So will just
> stripping give me more O/I-performance?

The answer is, it depends.

If you had some large number of drives to put in a RAID array, along
with a fast RAID controller and lots of battery backed cache set to
write-back, then it is unlikely you would get any better performance
from putting tables and indexes on lots of different discrete drives. 
Of course, you can use both, putting table spaces on top of different
stripe sets.

The important thing to consider is your usage pattern.  Will you be
writing in several small streams and reading in one or two big ones?  Or
vice versa?  Or will you have many read/write transactions in transit at
once?  Will you have a few heavy traffic tables and lot of low traffic
ones?  On and on.

There's a big difference between a data warehouse / OLAP and a
transactional engine / OLTP setup.

Note that there is probably better info on this in the -performance
archives than in the -admin ones...



view thread (3+ messages)

Message-ID: <1118326313.5758.189.camel@state.g2switchworks.com>
Permalink:  ../1118326313.5758.189.camel@state.g2switchworks.com/
Also on:    postgresql.org/message-id/1118326313.5758.189.camel@state.g2switchworks.com

 · 

reply

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Reply to all the recipients from your mail client; the link fills in
  the headers below: reply via email
  Some clients, webmail especially, drop In-Reply-To and References from
  a link, and the reply then starts a new thread: use the mbox below.

  To: pgsql-admin@postgresql.org
  Cc: smarlowe@g2switchworks.com, robert.koepferl@sonorys.at
  Subject: Re: Stripping raid vs. table spaces
  In-Reply-To: <1118326313.5758.189.camel@state.g2switchworks.com>
  References: <ED4E30DD9C43D5118DFB00508BBBA76EB16753@neptun.sonorys.at> <1118326313.5758.189.camel@state.g2switchworks.com>

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

This inbox is served by DDX for PostgreSQL; see mirroring instructions
for how to clone and mirror all data and code used for this inbox